| Contact angle | α | 25 | ° |
| Minimum chamfer dimension | rmin | 0,60 | mm |
| Distance between the apexes of the pressure cones | a | 14,40 | mm |
| Minimum diameter injection pitch | Etk min | 32,20 | mm |
| Shoulder diameter outer ring clearance | Da | H12 | |
| Diameter shaft shoulder clearance | da | h12 |
| Maximum diameter injection pitch | Etk max | 34,50 | mm |
| Maximum recess radius | ra max | 0,30 | mm |
| Shoulder diameter outer ring | Da | 42 | mm |
| Diameter shaft shoulder | da | 30 | mm |
| Limiting speed for oil lubrication | nG Oil | 80,000 | |
| Fatigue load limit, radial | Cur | 218 | N |
| Basic dynamic load rating, radial | Cr | 5,500 | |
| Outside diameter | D | 47 | mm |
| Limiting speed for grease lubrication | nG Grease | 53,000 | |
| Basic static load rating, radial | C0r | 2,700 | |
| Width | B | 12 | mm |
| Bore diameter | d | 25 | mm |
