| Contact angle | α | 25 | ° |
| Minimum chamfer dimension | rmin | 1,10 | mm |
| Distance between the apexes of the pressure cones | a | 27,10 | mm |
| Minimum diameter injection pitch | Etk min | 70,90 | mm |
| Shoulder diameter outer ring clearance | Da | H12 | |
| Diameter shaft shoulder clearance | da | h12 |
| Maximum diameter injection pitch | Etk max | 75,30 | mm |
| Maximum recess radius | ra max | 0,60 | mm |
| Shoulder diameter outer ring | Da | 88 | mm |
| Diameter shaft shoulder | da | 67 | mm |
| Limiting speed for oil lubrication | nG Oil | 36,000 | |
| Fatigue load limit, radial | Cur | 910 | N |
| Basic dynamic load rating, radial | Cr | 17,600 | |
| Outside diameter | D | 95 | mm |
| Limiting speed for grease lubrication | nG Grease | 24,000 | |
| Basic static load rating, radial | C0r | 11,300 | |
| Width | B | 18 | mm |
| Bore diameter | d | 60 | mm |
