| Contact angle | α | 25 | ° |
| Minimum chamfer dimension | rmin | 0,30 | mm |
| Distance between the apexes of the pressure cones | a | 9 | mm |
| Minimum diameter injection pitch | Etk min | 20,80 | mm |
| Shoulder diameter outer ring clearance | Da | H12 | |
| Diameter shaft shoulder clearance | da | h12 |
| Maximum diameter injection pitch | Etk max | 22,40 | mm |
| Maximum recess radius | ra max | 0,10 | mm |
| Shoulder diameter outer ring | Da | 27,50 | mm |
| Diameter shaft shoulder | da | 20 | mm |
| Limiting speed for oil lubrication | nG Oil | 120,000 | |
| Fatigue load limit, radial | Cur | 83 | N |
| Basic dynamic load rating, radial | Cr | 2,480 | |
| Outside diameter | D | 30 | mm |
| Limiting speed for grease lubrication | nG Grease | 80,000 | |
| Basic static load rating, radial | C0r | 1,030 | |
| Width | B | 7 | mm |
| Bore diameter | d | 17 | mm |
