| Contact angle | α | 15 | ° |
| Minimum chamfer dimension | rmin | 0,30 | mm |
| Distance between the apexes of the pressure cones | a | 8,50 | mm |
| Minimum diameter injection pitch | Etk min | 23,30 | mm |
| Shoulder diameter outer ring clearance | Da | H12 | |
| Diameter shaft shoulder clearance | da | h12 |
| Maximum diameter injection pitch | Etk max | 24,50 | mm |
| Maximum recess radius | ra max | 0,10 | mm |
| Shoulder diameter outer ring | Da | 32 | mm |
| Diameter shaft shoulder | da | 21 | mm |
| Limiting speed for oil lubrication | nG Oil | 100,000 | |
| Fatigue load limit, radial | Cur | 270 | N |
| Basic dynamic load rating, radial | Cr | 8,600 | |
| Outside diameter | D | 35 | mm |
| Limiting speed for grease lubrication | nG Grease | 63,000 | |
| Basic static load rating, radial | C0r | 3,350 | |
| Width | B | 10 | mm |
| Bore diameter | d | 17 | mm |
