| Upper limit deviation | Δu | 0,05 | mm |
| Distance between the apexes of the pressure cones | a | 16 | mm |
| Diameter of groove | D1 | 64,40 | mm |
| Stand out inner to outer ring | u | 0,03 | mm |
| Width of groove | m/2 | 0,75 | mm |
| Minimum chamfer dimension of inner ring back face | r1, 2 min | 1 | mm |
| Upper limit deviation | ΔDn | 0,19 | mm |
| Minimum diameter of shaft shoulder | db min | 46 | mm |
| Maximum fillet radius of shaft | ra max | 1 | mm |
| Maximum diameter of shaft shoulder | da max | 46 | mm |
| Maximum axial clamping force | 10,600 | ||
| Limiting speed | nG | 4,950 | |
| Basic static load rating, radial | C0r | 71,000 | |
| Width, outer ring | B | 20,50 | mm |
| Outside diameter | D | 68 | mm |
| Load carrying capacity of snap ring connection | FBR | 12,900 | |
| Fatigue load limit, radial | Cur | 8,500 | |
| Basic dynamic load rating, radial | Cr | 53,000 | |
| Width, inner ring | Bi | 21 | mm |
| Bore diameter | d | 40 | mm |
