| Upper limit deviation | Δu | 0,05 | mm |
| Distance between the apexes of the pressure cones | a | 28 | mm |
| Diameter of groove | D1 | 119,80 | mm |
| Stand out inner to outer ring | u | 0,03 | mm |
| Width of groove | m/2 | 1,25 | mm |
| Minimum chamfer dimension of inner ring back face | r1, 2 min | 1,50 | mm |
| Upper limit deviation | ΔDn | 0,25 | mm |
| Minimum diameter of shaft shoulder | db min | 87 | mm |
| Maximum fillet radius of shaft | ra max | 1,50 | mm |
| Maximum diameter of shaft shoulder | da max | 89 | mm |
| Maximum axial clamping force | 27,400 | ||
| Limiting speed | nG | 2,550 | |
| Basic static load rating, radial | C0r | 211,000 | |
| Width, outer ring | B | 29,50 | mm |
| Outside diameter | D | 125 | mm |
| Load carrying capacity of snap ring connection | FBR | 40,200 | |
| Fatigue load limit, radial | Cur | 26,500 | |
| Basic dynamic load rating, radial | Cr | 137,000 | |
| Width, inner ring | Bi | 30 | mm |
| Bore diameter | d | 80 | mm |
