a)
Reference edge
b)
Hole pattern:
c)
Length
| A | 80 | mm | |
| H (Measured with gauging shaft, nominal dimension d and length about 50 mm.) | 50 | mm | |
| m | 13 | ||
| N | 17 | mm | |
| O2 (ISO 4762-8.8) | M10 | ||
| T1 | 22 | mm | |
| U (DIN 7980, discontinued. Spring washer commercially available.) | 10 | ||
| V1 (Recommended design: No reference edge on opposite side (V1) and align parallel over shafts. ) | 7 | mm |
| e | 55 | ||
| H1 | 40 | mm | |
| m | 13 mm -0.5 | ||
| O1 (ISO 4762-8.8) | M10x30 | ||
| T | 60 | mm | |
| T2 | 13,50 | mm | |
| V | 19 | mm |
| m | 20,50 | kg |
