a)
Lubricating hole sealed with plastic cap
M6 when d ≤ 20
M8x1 when d ≥ 25
| D | 62 | mm | |
| E1 | 64 | mm | |
| H | 45 | mm | |
| H1 | 90 | mm | |
| L | 92 | mm |
| B | 108 | ||
| E2 | 80 | mm | |
| Tolerance for H (Two or more Linear Sets on one shaft are machined to the same dimension H while installed. Dimension H is reduced by 0.5 mm. ) | + 13 - 22 |
||
| H2 | 18,50 | mm | |
| L (R.... ... 85: l = 900 mm, R.... ... 87: l = 1200 mm, R.... ... 88: l = 2000 mm) | 600 | mm |
| amax | 150 | m/s² | |
| m | 2,10 | kg | |
| Operating conditions | Operating conditions |
| vmax | 3 | m/s | |
| m (shaft) | 9,80 | kg/m | |
| Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |