| Bore diameter | d | 50 | mm |
| Height | T | 78 | mm |
| Basic static load rating, axial | C0a | 300,000 | |
| Basic static load rating, radial | C0r | 82,000 | |
| Fatigue load limit, radial | Cur | 11,500 | |
| Limiting speed for grease lubrication | nG Grease | 1,200 |
| Outside diameter | D | 115 | mm |
| Basic dynamic load rating, axial | Ca | 90,000 | |
| Basic dynamic load rating, radial | Cr | 40,000 | |
| Fatigue load limit, axial | Cua | 28,000 | |
| Limiting speed for oil lubrication | nG Oil | 3,600 | |
| Bearing friction torque | MRL | 1,62 | Nm |
| Maximum diameter of housing shoulder | Da max | 79 | mm |
| Minimum diameter shaft shoulder | da min | 58 | mm |
| Height outer ring over wave washer | H1 | 58 | mm |
| Distance to lubrication hole | Ca | 12,50 | mm |
| Heeldiameter wave washer long | D2 | 60 | mm |
| Width, wave washer | B | 11,50 | mm |
| Width heel wave washer long | B2 | 14 | mm |
| Minimum chamfer dimension 1 | r1 min | 0,60 | mm |
| Pitch circle diameter (holes) | J | 94 | mm |
| Split | n x t | 30 | ° |
| Width, outer ring | C | 22,50 | mm |
| Rip diameter shaft washer | d1 | 78 | mm |
| Outside diameter wave washer long | D3 | 78 | mm |
| Width wave washer long | B1 | 29,50 | mm |
| Minimum chamfer dimension | rmin | 0,30 | mm |
| Diameter lubrication hole | ds | 6 | mm |
| Number (screwing holes) | n | 12 |
