| Contact angle | α | 40 | ° |
| Caliber diameter on inner ring wide side face | d2 | 38 | mm |
| Caliber diameter on outer ring small side face | D3 | 51,90 | mm |
| Shoulder diameter on outer ring wide side face | D1 | 47,10 | mm |
| Distance between the apexes of the pressure cones | a | 24 | mm |
| Shoulder diameter on inner ring wide side face | d1 | 41,30 | mm |
| Caliber diameter on outer ring wide side face | D2 | 47,70 | mm |
| Minimum chamfer dimension | rmin | 0,60 | mm |
| Maximum fillet radius of housing | ra1 max | 0,60 | mm |
| Maximum diameter of housing shoulder | Db max | 51,80 | mm |
| Minimum diameter of shaft shoulder | da min | 34,60 | mm |
| Maximum fillet radius of shaft | ra max | 1 | mm |
| Maximum diameter of housing shoulder | Da max | 50,40 | mm |
| Limiting speed | nG | 6,900 | |
| Basic static load rating, radial | C0r | 13,400 | |
| Width | B | 13 | mm |
| Bore diameter | d | 30 | mm |
| Fatigue load limit, radial | Cur | 930 | N |
| Basic dynamic load rating, radial | Cr | 19,900 | |
| Outside diameter | D | 55 | mm |
