| Contact angle | α | 40 | ° |
| Caliber diameter on inner ring wide side face | d2 | 83,10 | mm |
| Caliber diameter on outer ring small side face | D3 | 119,68 | mm |
| Shoulder diameter on outer ring wide side face | D1 | 103,40 | mm |
| Distance between the apexes of the pressure cones | a | 55,40 | mm |
| Shoulder diameter on inner ring wide side face | d1 | 87,30 | mm |
| Caliber diameter on outer ring wide side face | D2 | 106,86 | mm |
| Minimum chamfer dimension | rmin | 1,10 | mm |
| Maximum fillet radius of housing | ra1 max | 1 | mm |
| Maximum diameter of housing shoulder | Db max | 123 | mm |
| Minimum diameter of shaft shoulder | da min | 72 | mm |
| Maximum fillet radius of shaft | ra max | 2,10 | mm |
| Maximum diameter of housing shoulder | Da max | 118 | mm |
| Limiting speed | nG | 3,150 | |
| Basic static load rating, radial | C0r | 69,000 | |
| Width | B | 31 | mm |
| Bore diameter | d | 60 | mm |
| Fatigue load limit, radial | Cur | 4,750 | |
| Basic dynamic load rating, radial | Cr | 96,000 | |
| Outside diameter | D | 130 | mm |
