| D1 | 18 | mm | |
| C1 | 21,60 | H13 | |
| D | 19 | mm |
| C2 | 1,30 | ||
| C | 29 | mm |
| Permissible ambient temperature (min ... max) (Only unsealed Linear Bushings with steel ball retainers may be used at higher temperatures. Make allowance for reductions in load capacity. ) | -10 °C ... +80 °C | ||
| Shaft radial clearance h6 (Determined from working bore diameter and shaft tolerance statistics. Recommended housing bore tolerance: H6 or H7. ) | + 18 + 5 |
||
| Rows of balls | 4 | ||
| Breakaway force (One wiper seal: Multiply by a factor of 0.5.) | 2 | N | |
| m | 0,03 | kg | |
| amax | 100 | m/s² |
| Operating conditions | Operating conditions | ||
| Working bore diameter tolerance | + 8 0 |
||
| m (Friction coefficients of unsealed Linear Bushings when lubricated with oil. The friction coefficient is lowest under heavy load, but can still be above the specified value even under a low load. ) | 0,001 ... 0,004 | ||
| FR (One wiper seal: Multiply by a factor of 0.5.,Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 1 | N | |
| vmax | 2,50 | m/s |
