| e (Minimum size in relation to Ø d.) | 36,30 | ||
| C2 | 4,15 | ||
| C | 165 | mm | |
| D | 120 | mm |
| D1 | 114 | mm | |
| C1 | 133,30 | H13 | |
| A | 54 | mm |
| Permissible ambient temperature (min ... max) (Only unsealed Linear Bushings with steel ball retainers may be used at higher temperatures. Make allowance for reductions in load capacity. ) | -10 °C ... +80 °C | ||
| Shaft radial clearance h6/bore H7 | + 71 + 24 |
||
| m (Friction coefficients of unsealed Linear Bushings when lubricated with oil. The friction coefficient is lowest under heavy load, but can still be above the specified value even under a low load. ) | 0,001 ... 0,004 | ||
| FR (One wiper seal: Multiply by a factor of 0.5.,Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 20 | N | |
| vmax | 2 | m/s | |
| Operating conditions | Operating conditions |
| Shaft radial clearance h6/bore K7 | + 46 - 1 |
||
| Rows of balls | 5 | ||
| Breakaway force (One wiper seal: Multiply by a factor of 0.5.) | 60 | N | |
| m | 3,92 | kg | |
| amax | 50 | m/s² |
