a)
Reference edge
b)
Length
| B (Recommended design: No reference edge on opposite side (V1) and align parallel over shafts. ) | 30 | ||
| H1 (Measured with gauging shaft, nominal dimension d and length about 50 mm.) | 52 | mm | |
| H2 (Measured with gauging shaft, nominal dimension d and length about 50 mm.) | 7.5 mm ±0.012 | ||
| N | 11 | mm | |
| O2 (ISO 4762-8.8, recommendation applies for bolting in steel or cast iron threads.) | M6x16 | ||
| T1 | 8,50 | mm | |
| U (DIN 7980, discontinued. Spring washer commercially available.) | 6 | ||
| V1 (Recommended design: No reference edge on opposite side (V1) and align parallel over shafts. ) | 4 | mm |
| e | 15 mm ±0.15 | ||
| H2 | 7,50 | mm | |
| m | 8,30 | ||
| O1 (ISO 4762-8.8) | M6x45 | ||
| T | 50 | mm | |
| T2 | 8,50 | mm | |
| V | 15 | mm |
| m | 4,30 | kg |
