| Contact angle | α | 60 | ° |
| Pitch quantity of fixing holes | n | 12 | |
| Width of extraction slot | b | 3 | mm |
| Pitch circle diameter fixing holes | m | 200 | mm |
| Rib diameter inner ring | d1 | 146 | mm |
| Pitch separation angle of fixing holes | t | 30 | ° |
| Distance of extraction slot | I | 73 | mm |
| Fixing holes diameter | d2 | 14 | mm |
| Minimum chamfer dimension | rmin | 0,60 | mm |
| Connection thread for lubrication | M6 | ||
| Number of holes in adjacent construction | na | 12 | |
| Minimum diameter shaft | da min | 130 | mm |
| Pitch separation angle of holes in adjacent construction | ta | 30 | ° |
| Size of fixing screws | M12 |
| Bearing frictional torque | MR | 2,21 | Nm |
| Limiting speed for grease lubrication | nG Grease | 2,900 | |
| Basic static load rating, axial | C0a | 790,000 | |
| Width lower tolerance | -0,25 | mm | |
| Outside diameter lower tolerance | -0,02 | mm | |
| Bore diameter lower tolerance | -0,01 | mm |
| Thermally safe operating speed | nϑ | 2,000 | |
| Fatigue load limit, axial | Cua | 30,000 | |
| Basic dynamic load rating, axial | Ca | 295,000 | |
| Width | B | 85 | mm |
| Outside diameter | D | 230 | mm |
| Bore diameter | d | 100 | mm |
