a)
Reference edge
b)
Hole pattern:
c)
Length
| A | 200 | mm | |
| H (Measured with gauging shaft, nominal dimension d and length about 50 mm.) | 115 | mm | |
| m | 37 | ||
| N | 40 | mm | |
| O2 (ISO 4762-8.8) | M24 | ||
| T1 | 38,50 | mm | |
| U (DIN 7980, discontinued. Spring washer commercially available.) | 24 | ||
| V1 (Recommended design: No reference edge on opposite side (V1) and align parallel over shafts. ) | 18 | mm |
| e | 140 | ||
| H1 | 100 | mm | |
| m | 37 mm -0.5 | ||
| O1 (ISO 4762-8.8) | M24x80 | ||
| T | 150 | mm | |
| T2 | 30,50 | mm | |
| V | 42 | mm |
| m | 121 | kg |
