a)
Recommended position for pin holes (dimension E4 see general technical notes and information in the "Installation" section).
Rough-drilled holes may be present here from manufacturing. These may be bored open.
b)
Lube nipple, size 55:
Hydraulic-type lube nipple DIN 71412-B M6x8, B2 = 16 mm
Lube nipple, size 65:
Hydraulic-type lube nipple DIN 71412-B M8x1x8, B2 = 16 mm
When using different lube nipples, pay attention to the screw-in depth of 8 mm!
The lube nipple is included in the scope of delivery (not installed).
Connection is possible on end-face.
c)
Sealing plugs may be present here from manufacturing. Remove these prior to mounting.
d)
Size 65
| T | 120 | mm | |
| A | 140 | mm | |
| A2 | 53 | mm | |
| B | 199 mm +0.5 | ||
| E1 | 116 | mm | |
| E3 | 70 | mm | |
| E8.1 | - | ||
| E9.1 | - | ||
| H1 | 57 | mm | |
| Dimension H2 without cover strip | 47,85 | mm | |
| N1 | 18 | mm | |
| N6 | 29 mm ±0.5 | ||
| S2 | M14 | ||
| S9 | M5x8 |
| V1 | 12 | mm | |
| A1 | 70 | mm | |
| A3 | 43,50 | mm | |
| B1 | 155,50 | mm | |
| E2 | 95 | mm | |
| E8 | 80 | mm | |
| E9 | 22,30 | mm | |
| H | 70 | mm | |
| Dimension H2 with cover strip | 48,15 | mm | |
| K3 | 9 | mm | |
| N2 | 13,50 | mm | |
| S1 | 12,40 | mm | |
| ØS5 | 16 | mm |
| amax (If Fcomb > 2.8 • Fpr : amax = 50 m/s2) | 250 | m/s² | |
| m | 7,50 | kg | |
| Operating conditions | Operating conditions | ||
| Permissible ambient temperature (min ... max) (Up to 100 °C permissible for short periods. For operation at negative temperatures, please consult us. ) | -10 °C ... +80 °C |
| vmax | 3 | m/s | |
| m (Without friction of seal) | 0,002 ... 0,003 | ||
| Size | 55 |
