a)
For O-ring
Size 35/90: Ø 6 · 1.5 (mm)
Open lube port if necessary (see general technical notes and information in the "Maintenance" section).
b)
Recommended position for pin holes (dimension E4 see general technical notes and information in the "Installation" section).
Rough-drilled holes may be present here from manufacturing.
These may be bored open.
c)
Lube nipple, size 35/90:
Hydraulic-type lube nipple DIN 71412-B M6x8, B2 = 16 mm
When using different lube nipples, pay attention to the screw-in depth of 8 mm!
The lube nipple is included in the scope of delivery (not installed). Connection is possible on all sides.
d)
Sealing plugs may be present here from manufacturing. Remove these prior to mounting.
| V1 | 8 | mm | |
| A1 | 81 | mm | |
| A3 | 36 | mm | |
| B1 | 113,60 | mm | |
| E2 | 80 | mm | |
| E8.1 | 116 | mm | |
| E9.1 | 29,90 | mm | |
| H1 | 42,50 | mm | |
| K1 | 22,80 | mm | |
| K3 | 9 | mm | |
| N1 | 14 | mm | |
| N6 | 20.5 mm ±0.5 | ||
| S2 | M10 | ||
| S9 | M3x5 |
| A | 162 | mm | |
| A2 | 90 | mm | |
| B | 142 | ||
| E1 | 144 | mm | |
| E8 | 79 | mm | |
| E9 | 6,80 | mm | |
| H | 50 | mm | |
| H2 | 31,85 | mm | |
| K2 | 24,80 | mm | |
| K4 | 9 | mm | |
| N2 | 12 | mm | |
| S1 | 8,40 | mm | |
| ØS5 | 9 | mm | |
| T | 80 | mm |
| amax (If Fcomb > 2.8 • Fpr : amax = 50 m/s2) | 250 | m/s² | |
| m | 3,70 | kg | |
| Operating conditions | Operating conditions | ||
| Permissible ambient temperature (min ... max) (Up to 100 °C permissible for short periods. For operation at negative temperatures, please consult us. ) | -10 °C ... +80 °C |
| vmax | 3 | m/s | |
| m (Without friction of seal) | 0,002 ... 0,003 | ||
| Size | 35/90 |
