a)
For O-ring
Size 15: Ø 4 · 1.0 (mm)
Sizes 20 - 35: Ø 5 · 1.0 (mm)
Open the lube port if required.
b)
Recommended position for pin holes
Pre-drilled holes may be present at this position for manufacturing reasons. These can be drilled open.
c)
Lube nipple, sizes 15 – 20:
Funnel-type lube nipple DIN 3405-A M3x5, B2 = 1.6 mm
When using different lube nipples, observe the screw-in depth of 5 mm!
Lube nipple, sizes 25 - 35:
Hydraulic-type lube nipple DIN 71412-A M6x8, B2 = 9.5 mm
When using different lube nipples, observe the screw-in depth of 8 mm!
The lube nipple is included in the scope of delivery (not installed).
Connection possible on all sides.
d)
Sealing plugs maybe present at this position for manufacturing reasons. Remove before mounting.
| T | 60 | mm | |
| A | 47 | mm | |
| A2 | 15 | mm | |
| B | 58.2 mm | ||
| E1 | 38 | mm | |
| E3 | 26 | mm | |
| E9 | 6,70 | mm | |
| H1 | 19,90 | mm | |
| Dimension H2 without cover strip | 16,20 | mm | |
| K2 | 9,60 | mm | |
| K4 | 3,20 | mm | |
| N2 | 4,40 | mm | |
| S1 | 4,30 | mm | |
| ØS5 | 4,50 | mm |
| V1 | 5 | mm | |
| A1 | 23,50 | mm | |
| A3 | 16 | mm | |
| B1 | 39,20 | mm | |
| E2 | 30 | mm | |
| E8 | 24,55 | mm | |
| H | 24 | mm | |
| Dimension H2 with cover strip | 16,30 | mm | |
| K1 | 8 | mm | |
| K3 | 3,20 | mm | |
| N1 | 5,20 | mm | |
| N6 | 10.3 mm ±0.5 | ||
| S2 | M5 | ||
| S9 | M2.5x3.5 |
| amax (If Fcomb > 2.8 • Fpr : amax = 50 m/s2) | 500 | m/s² | |
| m | 0,20 | kg |
| vmax | 5 | m/s |
