a)
For O-ring
size 55/85: Ø 7 · 1.5 (mm)
size 65/100: Ø 12 · 1.5 (mm)
Open lube port if necessary (see section entitled "Lubrication").
b)
Recommended position for pin holes
(E4 dimensions, see section entitled "Notes for mounting", segment "Pinned fitting").
Rough-drilled holes made for may exist at this position for manufacturing reasons. They are suitable for drilling out.
c)
Lube nipple, thread M6 – 8 deep:
Connection possible on all sides.
Dimensions differ among different connection pieces. See "Accessories" for more information about lube ports.
| T3 | 32 | mm | |
| A | 165 | mm | |
| A2 | 85 | mm | |
| A3.1 | 40 | mm | |
| B1 | 162,10 | mm | |
| B3 | 216 | mm | |
| E2 | 95 | mm | |
| E8 | 40 | mm | |
| E9 | 10,75 | mm | |
| H | 80 | mm | |
| Dimension H2 with cover strip | 47,85 | mm | |
| K2 | 46,55 | mm | |
| N5 | 19 | mm | |
| N6 | 31.2 mm ±0.5 | ||
| ØS5 | 14 | mm |
| V1 | 12 | mm | |
| A1 | 82,50 | mm | |
| A3 | 40 | mm | |
| B | 205,50 | ||
| B2 | 209,50 | mm | |
| E1 | 140 | mm | |
| E3 | 40 | mm | |
| E8.2 | 113,60 | mm | |
| E9.2 | 50,75 | mm | |
| H1 | 68 | mm | |
| K1 | 43,55 | mm | |
| N3 | 19 | mm | |
| N5.1 | 19 | mm | |
| S2 | M12 | ||
| T (Dimension T = Division of the Roller Guide Rail) | 60 | mm |
| amax (Prerequisite: There must be preload, even during operation under load.) | 150 | m/s² | |
| m | 11,50 | kg | |
| m (Without friction of seal) | 0,0004 ... 0,001 | ||
| Size | 55/85 |
| vmax | 3 | m/s | |
| FR (Guideline value for frictional drags of the complete, sealed and lubricated roller runner blocks. ) | 70 | N | |
| Operating conditions | Operating conditions | ||
| Permissible ambient temperature (min ... max) (Brief peaks up to 100 °C are permitted. For even lower sub-zero temperatures, please consult us. ) | -10 °C ... +80 °C |
